He already get one

@ej113
Can you describe how to compile the hex for Teensy and Micro Pro ?
I tried to find out how to switch between the both, but I couldn't find it.
Thanks.
The FW still runs very stable

Thanks for the hint

Thanks.
Then I don't need them
BTW, the Z-Axis and Throttle is flickering when the FFB motors are on.
Is this only on my Joystick or do you also see this ?
But this is also with the original FW.

I just tested the adaptffbjoy-0.5.0beta1-shift_4axis_Teensy.hex.
looks quite good.
All buttons are working

Question: Do you use the 10k resistor ?
VCC
|
10k-PIN
|
GND

Are these the additional axsis ?

Hi,
Thanks for the link.
I will try make my own PCB for the Micro Pro with USB-C port.
This port hat more stability
BTW. I found out using 1.5nF makes the FFB a bit more stable with the old design.
Perhaps also with the Micro Pro

Thanks for your work.
The Arduino pro Micro version would be great. Much easier to get.
Do you have already a schematics for the Micro Pro ?

I send you a PM for a small improvement

Thanks for the cleanup. Works fine.

Hi,
Here should be the last one:
https://github.com/tloimu/adapt-ffb-joy
https://github.com/zduford/adapt-ffb-joy

I already contacted you several times (mail, pm), no response.

Hello,
If someone needs a ready to use device:
viewtopic.php?p=389914#p389914

Hello,
Since I found no complete one to order I created it myself including a small case
Based on the original schematics.
Tested with Sidewinder 3DPro firmware.
If someone want one, please contact me.