Hello,
I just purchased and attemted to instal an ASUS K8N with a Sempron 2600 64 CPU. I left everything intact less the MB and proc. Screwed the sucker down installed all plugs, connectors, and whatnots. I hit the power switch and waiting, waitin, waiting..no friggin beep. This darn thing won't post. I've checked and rechecked all connections multiple times. My brain is sliding down my neck. I'm hoping I can get this thing working without returning the MB.
other important sys specs:
Antec 430W PSU
Sapphire ATI X800 card
Kingston HyperX 1GB (dual 512) RAM
Don't know if that'll help but what the heck. Oh BTW the reason I replaced MB was the old one wouldn't hiold the drivers for the onboard audio, networking, VGA, etc. It would get stuck in a booting loop, and I suspected the MB. Now with ne MB and proc it will not post. Any help would be greatly appreciated. Thanks
HELP K8N don't work
- Perediablo
- DBB Ace
- Posts: 90
- Joined: Sun Oct 31, 2004 10:49 am
- Location: Fort Worth, TX
- Contact:
-
- Defender of the Night
- Posts: 13477
- Joined: Thu Nov 05, 1998 12:01 pm
- Location: Olathe, KS
- Contact:
Is this the same processor from the previous system? Stupid question, but did you actually remember to flip the switch on the back of the power supply to the on position?
"One spelling mistake can destroy your life. A Husband sent this to his wife : "I'm having a wonderful time. Wish you were her." - @RobinWilliams
- Perediablo
- DBB Ace
- Posts: 90
- Joined: Sun Oct 31, 2004 10:49 am
- Location: Fort Worth, TX
- Contact: