No one replying in the thread anymore.
I built it, twice, most recently using this image as its the most similar to my parts (ie the DSUB):
http://www.postimage.org/image.php?v=Ts1znUBJ
The Teensy v2 board can do its flashing tests just fine, but when I load 3DProR3.hex the LED just flashes faster and I get no new device in Windows.. nothing at all happens!?
Any who built the 3DP to USB adapter still about?
Whoops, sorry. Ment to reply but somehow it got burried. What are the values of the caps & resistors you are using ? Can you post a picture of your build ?
Also, the device will flash the LED while it's trying to find a joystick. It will start USB enumeration after it found one. Did you try your build w/ a different joystick ?
Also, the device will flash the LED while it's trying to find a joystick. It will start USB enumeration after it found one. Did you try your build w/ a different joystick ?
Re:
If you have more 2.2k's, just pair them and voala you have 1.1's.mattsimis wrote:I tried 1000pf Caps but 2watt 2.2kOHm resistors. Ill have to go buy more resistors to test lower.
I assume the Joystick works, was in a box here for years, I like it so much I never threw it out, but cannot test it else where either.
Re:
Parallel them…snoopy wrote:If you have more 2.2k's, just pair them and voala you have 1.1's.mattsimis wrote:I tried 1000pf Caps but 2watt 2.2kOHm resistors. Ill have to go buy more resistors to test lower.
I assume the Joystick works, was in a box here for years, I like it so much I never threw it out, but cannot test it else where either.
Sorry, just really anal about those things.