Help!, I screwed my computer

For system help, all hardware / software topics NOTE: use Coders Corner for all coders topics.

Moderators: Krom, Grendel

Post Reply
User avatar
Pumo
DBB Captain
DBB Captain
Posts: 779
Joined: Tue Jan 18, 2005 11:48 pm
Location: Mexico
Contact:

Help!, I screwed my computer

Post by Pumo »

While i was doing a windows clean install, by error I formatted the 99mb EFI boot partition.
I thought it was not big deal as I was installing the OS from the start anyway. I proceeded with the setup.

To my surprise, after the first restart to continue with windows installation, my computer went into an endless restart-shutdown loop. I disconnected it from the main power, cleared the CMOS with the jumper on the motherboard, and even took the CMOS battery off, but to no avail. My computer occasionally shows the bios splash screen, but it locks up on there, and doesn't obeys any command, so I can't enter the bios setup at all. It emits 3 very separated short beeps, then black screen afterwards. Also tried connecting/desconnecting several hardware pieces, but nothing, it is as if the motherboard went dead. The motherboard is a GA-B75M-D3V.

So, there's a simple solution to this, or I must change the motherboard?
It's really THAT bad to mess up with the EFI partition, that it can even 'kill' a motherboard?
[Pumo software main website] - Pumo Mines current release: v1.1 (12 Levels) -- [Official R.a.M. Land's website] (You can find my music here)
User avatar
CDN_Merlin
DBB_Master
DBB_Master
Posts: 9774
Joined: Thu Nov 05, 1998 12:01 pm
Location: Capital Of Canada

Re: Help!, I screwed my computer

Post by CDN_Merlin »

Corsair Vengeance 64GB 2x32 6000 DDR5, Asus PRIME B760-PLUS S1700 ATX, Corsair RM1000x 1000 Watt PS 80 Plus Gold,WD Black SN770 2TB NVMe M.2 SSD, WD Blue SN580 1TB M.2 NVMe SSD, Noctua NH-D15S Universal CPU Cooler, Intel Core i7-14700K 5.6GHz, Corsair 5000D AIRFLOW Tempered Glass Mid-Tower ATX, Asus GF RTX 4070 Ti Super ProArt OC 16GB Video, WD Black 6TB 7200RPM 256MB 3.5" SATA3, Windows 11
User avatar
Pumo
DBB Captain
DBB Captain
Posts: 779
Joined: Tue Jan 18, 2005 11:48 pm
Location: Mexico
Contact:

Re: Help!, I screwed my computer

Post by Pumo »

Unfortunately not, as I can't get past the POST screen, so there's no way to run any stuff from CD or USB. :(
[Pumo software main website] - Pumo Mines current release: v1.1 (12 Levels) -- [Official R.a.M. Land's website] (You can find my music here)
User avatar
fliptw
DBB DemiGod
DBB DemiGod
Posts: 6459
Joined: Sat Oct 24, 1998 2:01 am
Location: Calgary Alberta Canada

Re: Help!, I screwed my computer

Post by fliptw »

From what I've read, 3 short beeps means ram is sad, or your MB choose to give up the ghost when you did the install.
User avatar
Pumo
DBB Captain
DBB Captain
Posts: 779
Joined: Tue Jan 18, 2005 11:48 pm
Location: Mexico
Contact:

Re: Help!, I screwed my computer

Post by Pumo »

Oh well, so it may be most likely that the MB decided to die, will check that today. I think my warranty is still valid.
However, I'm a bit worried about this:

The HDD has traces of an OS that was being installed. Could this bring a problem again with the motherboard even if it's a new one with its factory settings, or I can safely plug said HDD to start a new Windows install on it with the new MB?
[Pumo software main website] - Pumo Mines current release: v1.1 (12 Levels) -- [Official R.a.M. Land's website] (You can find my music here)
User avatar
Tunnelcat
DBB Grand Master
DBB Grand Master
Posts: 13691
Joined: Sat Mar 24, 2007 12:32 pm
Location: Pacific Northwest, U.S.A.

Re: Help!, I screwed my computer

Post by Tunnelcat »

Got access to another computer to wipe and reformat the HDD first? Better yet, SSD prices have gone way down with better performance. Why not just get a new SSD to put the OS install on, or will Windows throw a fit with the different hardware? I'm much happier with my SSD performance over the old HDD that had the OS installed on from the factory. I re-purposed the old OS HDD for my games after reformatting it, so now I have 2 HDD's to hold my game libraries.
Cat (n.) A bipolar creature which would as soon gouge your eyes out as it would cuddle.
User avatar
Spidey
DBB Grand Master
DBB Grand Master
Posts: 10798
Joined: Thu Jun 28, 2001 2:01 am
Location: Earth

Re: Help!, I screwed my computer

Post by Spidey »

If I were you, I would try removing the HD, install it as a second HD on a different machine, reformat it, and replace the boot sector and anything else you did an oopise on. Then put it back in the machine and try again.

Be sure to format the sectors as they were originally.

Hint: always try to fix what you did wrong, before trying to fix other things. Screwing with the BIOS may have been a mistake.


But that’s only me, I’m far from an expert.
User avatar
Krom
DBB Database Master
DBB Database Master
Posts: 16125
Joined: Sun Nov 29, 1998 3:01 am
Location: Camping the energy center. BTW, did you know you can have up to 100 characters in this location box?
Contact:

Re: Help!, I screwed my computer

Post by Krom »

Your PC should be able to POST even without a hard drive installed. Stuff on the hard drive should have no impact on BIOS or its ability to POST. The three beeps error code would definitely point to different problems than something wrong with the partitions on the hard drive.
User avatar
Pumo
DBB Captain
DBB Captain
Posts: 779
Joined: Tue Jan 18, 2005 11:48 pm
Location: Mexico
Contact:

Re: Help!, I screwed my computer

Post by Pumo »

After taking the computer for maintenance, it resulted that the motherboard was indeed the culprit, although the PSU and HDD were also to blame (the HDD became damaged and the PSU was struggling a bit).

So I replaced the three components at once. A shame I didn't had the cash right now to buy the SSD as Tunnelcat suggested, that will have to wait until the next time.

After replacing the components everything is running fine, as I'm typing this message from the fixed computer (using Windows 10 by the way). :)
[Pumo software main website] - Pumo Mines current release: v1.1 (12 Levels) -- [Official R.a.M. Land's website] (You can find my music here)
User avatar
fliptw
DBB DemiGod
DBB DemiGod
Posts: 6459
Joined: Sat Oct 24, 1998 2:01 am
Location: Calgary Alberta Canada

Re: Help!, I screwed my computer

Post by fliptw »

what do you have your computer plugged into?
User avatar
Pumo
DBB Captain
DBB Captain
Posts: 779
Joined: Tue Jan 18, 2005 11:48 pm
Location: Mexico
Contact:

Re: Help!, I screwed my computer

Post by Pumo »

To a hook up lead, with proper ground installation.
[Pumo software main website] - Pumo Mines current release: v1.1 (12 Levels) -- [Official R.a.M. Land's website] (You can find my music here)
User avatar
fliptw
DBB DemiGod
DBB DemiGod
Posts: 6459
Joined: Sat Oct 24, 1998 2:01 am
Location: Calgary Alberta Canada

Re: Help!, I screwed my computer

Post by fliptw »

no surge protection?
User avatar
Krom
DBB Database Master
DBB Database Master
Posts: 16125
Joined: Sun Nov 29, 1998 3:01 am
Location: Camping the energy center. BTW, did you know you can have up to 100 characters in this location box?
Contact:

Re: Help!, I screwed my computer

Post by Krom »

Sounds like a bad PSU fried it (I've seen that happen to machines before).
User avatar
Tunnelcat
DBB Grand Master
DBB Grand Master
Posts: 13691
Joined: Sat Mar 24, 2007 12:32 pm
Location: Pacific Northwest, U.S.A.

Re: Help!, I screwed my computer

Post by Tunnelcat »

Pumo wrote:After taking the computer for maintenance, it resulted that the motherboard was indeed the culprit, although the PSU and HDD were also to blame (the HDD became damaged and the PSU was struggling a bit).

So I replaced the three components at once. A shame I didn't had the cash right now to buy the SSD as Tunnelcat suggested, that will have to wait until the next time.

After replacing the components everything is running fine, as I'm typing this message from the fixed computer (using Windows 10 by the way). :)
Well, save up for that SSD. You'll be properly impressed by it's performance. But now you have to clone or reinstall the OS if you get one. Even my 4 year old computer is now purring along, although I bought a Samsung EVO and there is still a performance read issue with old data, not that it's noticeable.
Cat (n.) A bipolar creature which would as soon gouge your eyes out as it would cuddle.
User avatar
Pumo
DBB Captain
DBB Captain
Posts: 779
Joined: Tue Jan 18, 2005 11:48 pm
Location: Mexico
Contact:

Re: Help!, I screwed my computer

Post by Pumo »

tunnelcat wrote:Well, save up for that SSD. You'll be properly impressed by it's performance. But now you have to clone or reinstall the OS if you get one. Even my 4 year old computer is now purring along, although I bought a Samsung EVO and there is still a performance read issue with old data, not that it's noticeable.
Yeah, I'm tempted to buy a SSD since some time already, but I need to find a good balance between performance, capacity and price (as I'm having lots of expenses as of lately, so I can only afford something relatively cheap).
fliptw wrote:no surge protection?
I will check that. But after more researching (as I was not completely sure as if that was it's name in english) I'm using something like this, rather than a 'hook up lead': http://s3.trianglecables.com.s3.amazona ... 5-ft-1.jpg

So it may have surge protection? I'm not completely sure.
Krom wrote:Sounds like a bad PSU fried it (I've seen that happen to machines before).
Most probably. I bought a 600W PSU and a Biostar H61MGV3 motherboard and everything seems to be working perfectly fine as for now.
-

Now on the other hand, the 'damaged' HDD was not really damaged. I ran several tests on it and it has perfect health, it just needed a complete wiping and a run of DISKPART CLEAN to re-partition it and format it correctly.
After that, I cloned my installed OS from the new HDD to the not-really-damaged one and it works perfectly! :)

I did that as it seems I bought an old model HDD, and found it to be noisy!
So I definitely prefer my previous and much quieter HDD (that I thought it to be damaged).
However, I left the OS installed on the new noisy one as a backup just in case, but will store it in the meantime.

Anyway, it seems everything is going well as for now. Thanks everyone for your advice! :D
[Pumo software main website] - Pumo Mines current release: v1.1 (12 Levels) -- [Official R.a.M. Land's website] (You can find my music here)
Post Reply