Laptop standby problem

Plague · Post by **Plague** » Fri Dec 26, 2003 12:15 pm

P4M 1.7Ghz
512MB DDR RAM
20GB HDD
GeForce4 Go 420 32MB
Windows XP Pro (all service packs, all critical updates)

I decided to try letting my computer go into standby mode (after 30 minutes idle) after giving it a format. It worked for a while, but then began to do a full boot every time. So I decide to turn it off and just leave it on all day like I did before. I turned off all the standby options in Power Options, yet it still goes into standby after a set period of time. What gives?

Tetrad · Post by **Tetrad** » Fri Dec 26, 2003 12:18 pm

Maybe go into bios options and turning off power saving options there?

Plague · Post by **Plague** » Fri Dec 26, 2003 4:55 pm

I checked that, there aren't any.

Krom · Post by **Krom** » Sat Dec 27, 2003 12:09 am

Check in windows power options, make sure the changes took, it overrides BIOS.

Try setting it to always on.

Vander · Post by **Vander** » Sat Dec 27, 2003 12:49 am

What brand of laptop is it?

My suggestion is to check the manufacturer's website for their latest power management software. If you did a format, you would have to reload this software after installing Windows.

Some laptops use proprietary power management software, and some use software that works with windows power management and adds functionality above what base Windows will offer to taylor it to your specific laptop.

Plague · Post by **Plague** » Wed Jan 07, 2004 10:45 am

Sorry I waited so long to bring this up again, been busy. Anyway, it's still bugging me, so:

It's a Chembook 3020E Diamond. I don't remember having to use any other software other than Windows to adjust my power properties before I formatted. If I can't resolve this myself within a couple of days then I'm calling them.

Vander · Post by **Vander** » Wed Jan 07, 2004 1:08 pm

I looked at the chembook site, and they don't seem to have support. Did the laptop come with a driver CD?

Plague · Post by **Plague** » Wed Jan 07, 2004 8:44 pm

It did come with a driver CD, which I installed in it's entirety upon reformatting. ChemUSA does have support, which I contacted this afternoon. If they find the problem, I'll post it here.