DescentBB

Hi,I have problem with my Sidewinder Force Feedback PRO,I have this joystick for 2 years and it was working fine until the power connector broked.I soldered 2 wires with new power connector to pins on back side of PCB.After this when i plug joystick to electrical line the handle turns immedietly up and there is buzz sound coming from motor when the handle reach max range in its direction and when i put hand on joystick and pull stick to centre its starts shaking also in the same direction,but it dont lloks that second motor is dead at all beacuase when i tried to play game i got some force feedback from the second axis.

Sounds like you may have crossed the wires or bridged some solder points. Check undernaeth the board and see if you bridged any traces.

I checked PCB,it looks OK nothing seems crossed,probably some components had to be damaged because of heat during soldering :/

...and this is why you always use heat sinks on nearby components when soldering.

Better to test with a circuit tester to see if things are really crossed or not, sometimes visual inspection isn't good enough.