DescentBB

Posted: **Sun Dec 04, 2005 6:57 pm**

Monitor problem

Bought a flat panel Sceptre X96-Komodo V11A which worked fine for 2 weeks then went fuzzy.

It did not come w/ a driver but XP found it.

Now it's fuzzy and you can't change resolution.

I downloaded a driver from Sceptre which didn't help so I re-attached my Dell monitor which is also not working correctly and "updating driver" did not help.

What next?

Posted: **Sun Dec 04, 2005 6:58 pm**

2 montiors not working correctly... gfx card?

Posted: **Sun Dec 04, 2005 8:43 pm**

Can I try one from an older eMachine to see if it is the card?

Posted: **Mon Dec 05, 2005 12:40 am**

Would be a good place to start trying

Posted: **Mon Dec 05, 2005 1:37 am**

yeah ... i would say if you had a problem with one monitor and a second monitor is giving you trouble... best thing to do is start looking at the card not the monitor, even if they appear to be different problems, since different monitors will exibhit voltage / port problems differently, all they do is show you the information they are getting. if that info is bad, then it will do the best it can to interpret.

Posted: **Mon Dec 05, 2005 8:40 am**

I'll give it a try, thanks.

Posted: **Tue Dec 06, 2005 1:53 pm**

It was the graphics card. Thanks for the "posts".

Posted: **Wed Dec 07, 2005 12:52 am**

you're welcome

Posted: **Wed Dec 07, 2005 7:00 am**

I've actually fixed a similar problem on a couple machines for family & friends. Apparently some LCD monitors let you set an inappropriate refresh rate and that will cause fuzzyness, snow and other problems on the monitor.

Glad you found the problem, but I'd check that card in another computer, it may be that you had a similar problem to the one I mentioned above, which was corrected when you installed a new card.

OTOH, It may not.